Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
service center or by a well capable person in order
to avoid any electrical involved accident.
Do not use your "table fan" if it shows any damage
sign or if the electrical power cord or its plug are
damaged.
Please keep the electrical cord away from the
mobile parts of your fan, as well as away from sharp
objects.
Do not use your fan if you have dropped it and
shows clear visible signs of any damage.
Do not set your fan on wet or humid surfaces, and
avoid cleaning the floor around your unit if this is
under operation.
This fan in not a toy, always make sure children do
not play with it.
Parts identification
1. Fan blades (mobile parts)
2. Safety grid
3. Base
4. Adjusting position knobs
5. Operation/Speed control panel
6. Cord winder
2.
4
Wall mount:
www.comfortzoneproducts.com
.1
4
.3
.5
.6
Fig. S1
By using a 1/4" drill (not included) make two holes
horizontally aligned with 7,6 in of separation (it is not
recommended to install the wall support attachment
on prefabricated walls or not stable walls).
Insert in every hole a 1/4" plastic dowel (included),
then insert in each plastic dowel a 1/4" x 1" screw
(included) no more than 0,8 in deep (Fig. S1)
Insert the screw into base hole and fix well, hang fan
on the wall and make sure it is properly set.
HOW TO OPERATE
Set your "table fan" on a stable surface, do not
set on a rug or on a carpet or over furniture or on
an uneven floor or over any fabric surface.
Plug the unit to the power supply socket, and
please verify it is turned off and on the "0"
position on the speed control panel before.
In order to put the fan on movement, turn the
switch clockwise to set on the preferred speed:
0=off, 3=high, 2=medium, 1=low.
Do not set your "table fan" closer than 3.94
inches of any surface, such as the wall, curtains
or any furniture which could block the air flow.
IMPORTANT: Before adjusting the air flow or
moving this fan, make sure that it is set on the "0"
position on the speed control panel (off).
CLEANING AND MAINTENANCE
Turn the "table fan" off, on "0" position on the
speed panel.
Unplug your "table fan" from the power supply.
Make sure to use a soft, lightly dipped on soap,
cloth. Do not immerse the fan on water or any
other fluid, do not let any water on the inside
of the unit neither. Do not use gasoline, thinner
or any other flammable o corrosive substances,
since these could not only damage the fan, but
the fumes could be toxic, as well.
Make sure to maintain the blades free of dust.
Vacuum the "table fan" blades as frequently as
your appliance require it.
STORAGE
Turn off the "table fan" by selecting the "0" on the
speed panel, and unplug it from the power supply.
In a vertical position allow the unit to come to a
complete stop. Roll the power cord around cord
winder, never around the unit, and storage the unit
in a clean, dry place on a vertical position.
3
CZHV101BS-EU
Publicidad
Tabla de contenido
