Emergency Procedure - Gude GH 5.6-50 Traducción Del Manual Original

Specified Conditions of Use
The shredder is designed exclusively for shredding
fibrous or woody garden waste such as hedge and
tree trimmings, branches, bark or fir cones.
The shredder must not be filled with stones, glass,
metal, bones, plastics or material waste.
Please note that permissible uses for the tool could
be limited by national regulations. It is necessary to
comply with the regulations applicable in the coun-
try where the truck is used.
Do not use the device near flammable liquids or
gases. Risk of fire and explosion in case of short
circuit.
Use the appliance only outside, never use it in con-
fined and bad ventilated areas.
The safety systems and safety devices of the device
must not be manipulated or deactivated.
Please note that our equipment has not been
designed for commercial, craft or industrial use. If the
equipment is used in commercial, craft or industrial
operation or for similar activities, we cannot assume
any liability.
Risk of injury
Rotating blades may lead to serious injuries
by cutting or amputating parts of the body.
· Be careful to avoid injury by the cutting
tools. Careful appliance handling reduces
the risk of injury by knife.
· Do not touch any dangerous moving parts
before the machine has been disconnected
from the power supply and the moving parts
have come to a complete standstill.
· All protection covers and safety devices
must be correctly attached to operate the
device.
Never use the machine with a damaged cover or
protective device or without cover or protective
devices.
Keep children and other persons including
animals in a safe distance when using the
appliance.
Minimum safe distance is 5 m.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
Starting-up the machine
Check all screw and plug-in connections and protec-
tive equipment if firm and tightened properly and
whether all moving parts are running smooth whene-
ver the appliance is to be put into operation.
Inspect before each use:
· Proper function of the on and off button, incl.
the emergency switch.
Before starting the machine, make sure that the
feeder is empty.
The appliance must not be used if damaged or safety
equipment is defective. Replace any worn-out and
damaged parts.
Do not stand in the ejection zone when operating the
machine.
The engine must be filled with engine oil before the
initial commissioning.
Check the oil level every time before commissioning.
Fill with engine oil if required.
Work area safety
Use this device in well-ventilated outdoor areas only.
In closed rooms, exhaust gases containing carbon
monoxide may have fatal effects.
When being operated, the machine must stand on a
horizontal and flat surface and the floor around the
machine must be flat, well-maintained and with no
waste, such as sawdust and cuttings.
Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
The machine may only be used if it is fully assembled.
Operation of a machine that is not fully assembled is
strictly prohibited.
Transport
Handling equipment to be used only when handling
the machine. Make sure the device cannot roll away,
fall over or tip over with suitable fastening devices.
Do not transport the machine if the energy source is
running.

Emergency procedure

Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information: 1. Accident site, 2.
Accident type, 3. Number of injured persons, 4. Injury
type(s)
Residual Risk
Despite the observance of the operating instructions
there still may be some hidden residual risks.
ENGLISH
35