2
1. Place thread and spool holder onto spool pin.
2. Pull the thread from spool and guide the thread through bobbin tension guide.
3. Put thread through the small hole of the bobbin from inside. Aligning hole in
bobbin with driving pin on bobbin winder, place bobbin onto the bobbin wider
shaft.
4. Hold the free end of the thread, and slide the main switch to "START" position.
Press on the foot control to start the sewing machine.
5. Cut the thread end on the top of the bobbin by thread trimmer. Then continue
winding until desired amount of the thread is wound. Cut thread and remove
the bobbin.
Winding the bobbin
1
2
STOP
START
4
1
3
5
4
3
4