General Safety Rules - Genesis GTS10SB Manual Del Operario

10" Table Saw
Operator's Manual
Specifications
• Model #---------------------------------- GTS10SB
• Input ------------------------------------ 120V ~ /60Hz, 15.0 Amp
• Blade Size ------------------------------- 10" (254 mm)
• Blade Bevel ------------------------------ 0-45 Degrees
• No-Load Blade Speed-------------------- 4,800 RPM
• Arbor Size -------------------------------- 5/8" (16 mm)
• Table Size ------------------------------- 24" L x 20" W
• Cutting Capacity at 90 degrees ---------- 3"
• Cutting Capacity at 45 degrees ---------- 2-1/2"
Includes: Table Saw, 40T Carbide Blade, Miter Gauge, Rip Fence, Push-Stick, Metal Stand and
Wrenches.
warning:
this operator's manual before operating this tool. Save this Manual for future
reference.
Toll-Free Help line: 1-888-552-8665
WeAR yOuR
SAFeTy GLASSeS
FOReSIGHT IS BeTTeR
THAN NO SIGHT
look for this symbol to point out important safety
precautions. it means attention!!! Your safety is
involved.

general SaFeTY rUleS

warning:
drilling, and other construction activities contains chemicals known to cause
cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this
type of work. To reduce your exposure to these chemicals: work in a well
ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles.
2
To reduce the risk of injury, user must read and understand
warning:
objects being thrown into your eyes, which can result in severe eye damage.
Before beginning tool operation, always wear safety goggles or safety glasses
with side shields and a full face shield when needed. We recommend Wide
Vision Safety Mask for use over eyeglasses or standard safety glasses with side
shields. Always wear eye protection which is marked to comply with ANSI Z87.1.
Some dust created by power sanding, sawing, grinding,
10" Table Saw
Operator's Manual
15 aMP
The Operation of any power tool can result in foreign
GTS10SB