Connecting / Disconnecting Your Ego Cup Fm With A Bluetooth Device - Flaircomm Technologies EGO Cup FM Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
NOTE:
• If your mobile phone shows that paring is failed and the EGO Cup FM is still in the paring mode, you need to go back to above
steps 2-4 to repeat the paring process.
• The EGO Cup FM can be paired with up to 8 Bluetooth devices (including mobile phones). The corresponding 8 sets of pairing
information are recorded by the EGO Cup FM. Each paired device can wireless communicated with the EGO Cup FM after
setting up a Bluetooth connection.
• Right after the pairing process is successful, it is possible that your mobile phone name cannot be displayed (i.e. because the
name exceeds 12 characters allowed). If this is the case, the Bluetooth symbol will appear on the display instead of the mobile
phone name.

4.2.2. Connecting / Disconnecting your EGO Cup FM with a Bluetooth Device

To use the EGO Cup FM with a Bluetooth device the Bluetooth connection between both devices shall be established in advance. If two
Bluetooth devices have been paired once, you can simply reconnect them, even when the two devices have been disconnected or
turned off in the mean time.
Connecting your EGO Cup FM with a Bluetooth mobile phone
Initiating a request from either the EGO Cup FM or the mobile phone can set up Bluetooth connection.
• If you want to initiate the connection request from the EGO Cup FM: Place the EGO Cup FM close to the Bluetooth mobile
phone, then press
button briefly. The
successfully connected.
• If you want to initiate the connection request from the Bluetooth mobile phone: Place the EGO Cup FM close to the Bluetooth
mobile phone and then follow the mobile phone's user guide to find the EGO Cup FM and send connection request.
Disconnecting your EGO Cup FM from your Bluetooth mobile phone:
When the EGO Cup FM is connected with Bluetooth mobile phone (or in the connected mode), you can disconnect them either by
pressing and holding
button for at least 3 seconds or by following the mobile phone's user guide and initiating disconnection from the
phone side. After disconnecting, you will hear one low tone, then the blue LED will give 1 blink per 3 seconds and you will see "EGO
CUP FM" on the LCD-display.
English
symbol will appear shortly on the LCD and one high tone will be heard when it's
8

Publicidad

Tabla de contenido
loading

Tabla de contenido