Reversing The Door Swing - Orien FS50OD Manual Del Usuario

1. Place a carpenter's level on top of the product to see if the ice maker is level from front to
back and side to side.
2. Adjust the height of the legs as follows:
Turn the leveling legs to the right to lower that side of the ice maker.
Turn the leveling legs to the left to raise that side of the ice maker.
IMPORTANT: Once you are ready to install it in a cabinet or directly on the floor, you must
adjust the legs to level the ice maker.
Reversing the Door Swing
TOOLS NEEDED: Flat screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the ice maker or disconnect power.
To remove door from hinges:
1. Remove the top hinge cover.
2. Using a Phillips screwdriver, remove the screws, then remove top hinge mat and top hinge.
Keep the parts together and set them aside.
3. Lift the door off of the bottom hinge and turn it upside down so that the handle is on the right.
Set the door aside.
12