Quick RDS 1540 Manual Del Usuario página 18

NOTIFICATION SIGNS
GB
FIELD DESCRIPTION
MASTER OUT MASTER output voltage.
SLAVE A OUT Slave A output voltage.
SLAVE B OUT Slave B output voltage.
CURRENT Total current delivered by the battery charger.
STATUS Battery charger status.
The STATUS field can display the messages shown in the following table:
MESSAGES DESCRIPTION
The battery charger is running a check after leaving STAND-BY status and after leaving
INTIT CHECK
programming.
FLOAT *
The battery charger is in FLOAT status (see the table below).
ABSORPT *
The battery charger is in ABSORPTION status (see the table below).
BULK *
The battery charger is in BULK status (see the table below).
MONITOR
The battery charger is in MONITOR status.
STANDBY
The battery charger is in Stand-by status.
PROGRAM
The user has entered battery charger programming.
Connection not present. If the battery charger is switched off, this is the correct signal to see.
NO LINK
If the battery charger is switched on, try switching the instrument off and on, check the connection of
the data transmission cable, the unit's configuration, and the CAN priority and termination.
The battery charger is in error status. In the place of the character #, the battery charger's
ERROR E#
respective error code number appears (numbers in a range of 1 - 9; consult the battery charger's
operation manual).
In the place of the character *, the messages displayed in the following table can appear:
*
DESCRIPTION
U
AC voltage low.
L
Power limitation.
F
Incorrect battery temperature.
C
Communication problem on the CAN BUS.
H
Half power mode.
S
Digital control of the parallel units on.
For more details, refer to the manual of use of the battery charger for which the instrument displays informa-
tion.
18
RDS 1540 - REV003A