About Video Outputs Connection; Connecting Antennas - Pioneer HTP-072 Guia De Inicio Rapido

Connecting a TV and playback component
If you have an HDMI or DVI (with HDCP) equipped component (Blu-ray Disc player, etc.), you can connect it to this
receiver using a commercially available HDMI cable.
• The following connection/setting is required to listen to the sound of the TV over this receiver.
– If the TV does not support the HDMI Audio Return Channel function, connect the receiver and TV with audio
cables (as shown).
– If the TV supports the HDMI Audio Return Channel function, the sound of the TV is input to the receiver via the
HDMI terminal, so there is no need to connect an audio cable. In this case, set ARC at HDMI Setup to ON.
– The ARC function may not operate even with the above connections. If this is the case, connect the receiver
and the TV with an audio cable.
– Please refer to the TV's operation manual for directions on connections and setup for the TV.
HDMI/DVI-compatible components
(Blu-ray Disc player, etc.)
HDMI OUT
IN IN
HDMI
DVD SAT/CBL GAME BD
ANTENNA VIDEO AUDIO
R
AM LOOP
DVD IN
SAT/CBL
IN
ANALOG IN 1
(CD)
FM UNBAL
75
ASSIGNABLE
MONITOR
OUT
Plugging the receiver
Only plug in after you have connected all your components to this receiver, including the speakers.
U.K. model
1
Plug the supplied power cord into the AC IN socket on the back of the receiver.
2
Plug the other end into a power outlet.
European, Australia and New Zealand models
1
Plug the AC power cord into a convenient AC power outlet.
4
En
HDMI/DVI-compatible TV
HDMI IN DIGITAL AUDIO OUT
OPTICAL
If the TV does not support the
HDMI Audio Return Channel
function, this connection is
required to listen to the TV
sound over the receiver.
OUT
IN IN
1 1
( CD ) ( TV )
ASSIGNABLE ASSIGNABLE
COAXIAL OPTICAL
A
SPEAKERS
L FRONT CENTER SURROUND
R L R L
AC IN
If the device you wish to
connect does not have an
HDMI output terminal, it
can be connected via these
 "
terminals. Connecting
your component with no HDMI
terminal"
SUBWOOFER
To power outlet

About video outputs connection

This receiver is not loaded with a video converter.
When you use HDMI cables for connecting to the
input device, the same cables should be used for
connecting to the TV.
The signals input from the analog (composite) video
input of this unit will not be output from the HDMI
OUT.

Connecting antennas

Connect the AM loop antenna and the FM wire antenna
as shown below.
ANTENNA
AM LOOP
4
FM UNBAL
75
1
CAUTION
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
ask your nearest Pioneer authorized independent
service company for a replacement.
• Do not use any power cord other than the one
supplied with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular
use, e.g., when on vacation.
2
3