Spare Parts - SCANGRIP CANVIK TITAN Manual De Instrucciones

CONICAL SPRINGS:
Use the raised jaw 90.0060 to ensure that the centre line of the spring is parallel to the compressing
device. Do not use the coil spring compressor for conical springs if this is not the case. Fit the
raised jaw 90.0060 at the spring end with the smallest diameter.
It is very important for your safety that the jaws are fitted correctly and that the
bolts are firmly tightened before use.
BALL SPRINGS:
Use the raised jaw 90.0060 to ensure that the centre line of the spring is parallel to the compressing
device. Do not use the coil spring compressor for ball springs if this is not the case. Fit raised jaws
90.0060 at both spring ends.
It is very important for your safety that the jaws are fitted correctly and that the bolts are firmly
tightened before use.
ACCESSORIES
Special purpose jaws for all kinds of springs:
Jaw "counterclock" for springs ø145-195mm
Jaw fitting spring diameters of Ø140-175 mm
Jaw fitting spring diameters of Ø180-230 mm
Jaw fitting spring diameters of Ø80-120 mm
Jaw, Ø80-145 mm for conical and ball springs
Jaw for BMW E39, E46, Renault Megane II and Toyota Avensis
Jaw for Mercedes C-class
Jaw for Mercedes E-class and Renault Megane II
Jaws (pair) for Peugeot Break, Citroën C15
Jaw for Chrysler Grand Voyager, "counter clock" spring

SPARE PARTS

Standard jaw for ø80-200mm incl polyurethane insert
Foot pedal
Trolley wheel
90.0025
90.0030
90.0040
90.0050
90.0060
90.0070
90.0080
90.0090
90.0100
90.0120
10.0010
10.0055.01
10.0055.02
9
GB