Refilling The Tank; Maintenance Schedule; Changing The Engine Oil - Viking EVC 200 Manual De Instrucciones

6.2 Refilling the tank

The engine is approved for
unleaded petrol. Unleaded petrol
burns with fewer residues, reduces
deposits on the spark plug and extends the
service life of the exhaust system.
Requirements for the fuel:
– Fresh, clean and unleaded petrol
– Rating of at least 85 octane
– Maximum ethanol content 10 % (E10).
VIKING recommends VIKING MotoPlus.
This fuel is virtually free of benzene,
sulphur and toxic aromatics.
Tank capacity: 0,9 litres
Avoid damage to the machine!
VIKING recommends always using
fresh, good quality fuel and never
using petrol with an oil additive (2-
stroke mixture). Do not use stale or
contaminated fuel. Avoid
contaminating the tank contents
with dirt and water. Do not use
unapproved petrol like E85.
Change the petrol brand if you hear
knocking or ringing. If necessary,
contact your specialist dealer;
VIKING recommends VIKING
specialist dealers.
● Park the VIKING gardening power tool
on a flat surface, stop the engine and
allow to cool.
● Unscrew tank cap (1).
0478 983 9900 A - EN
● Add petrol only as far as the
lower edge of the filler neck
so that the fuel has room to
3
expand.
Use a suitable funnel.
● Screw tank cap (1) back on
again.
7. Maintenance

7.1 Maintenance schedule

The specified service intervals must be
strictly observed for safe, economical and
fault-free operation.
Risk of injury!
Stop the engine and detach the
spark plug socket before all
maintenance operations.
Before each use:
● Check the oil filling level (
● Check the air filter (
After the first 5 operating hours or after
1 month:
● Change the engine oil (
Every 25 operating hours or every 3
months:
● Clean the air filter (
Every 50 operating hours or every 6
months:
● Change the engine oil (
● Check the spark plug (
Every 100 operating hours or every 12
months:
● Have the inspection carried out by a
specialist dealer. VIKING recommends
VIKING specialist dealers.
7.2 Checking and cleaning the air
filters
● Park the VIKING gardening
power tool on a flat surface. Clean the
air filter cover and housing.
● Press in tabs (1) and remove cover (2).
● Remove large filter (3) and small
filter (4).
● Check all parts of the air filter for
damage and replace if necessary. In
particular replace damaged or very dirty
foam filters.
Clean filters (3, 4) every 25 hours of
operation or every 3 months. Clean
filters (3, 4) more frequently if using the
6.1)
VIKING gardening power tool in dusty
conditions.
7.2)
● To clean:
Tap the foam filter to dislodge dirt and
rinse with soapy water – dispose of
7.3)
contaminated soapy water in an
environmentally friendly manner.
Immerse a new or cleaned small
filter (4) in fresh engine oil before
7.2)
installing – squeeze out excess engine
oil.
● Assemble the air filter in reverse order.
7.3)
7.4)

7.3 Changing the engine oil

Engine oil should be drained from a
warm engine – warm engine oil
drains quickly and completely.
4
5
9