PNI VOYAGER S2000 Manual De Usuario página 8

EN
3. G-Sensor (Gravity Sensor)
In the event of a shock or accident, the DVR immediately blocks the video from the moment of
impact. This file will not be erased by the cyclical record.
4. Parking Monitor
When parking the car, turn on the parking assistant. The DVR will record during the car's stationary
time. This way you will have a witness in case of theft of the car or damages to it (scratches). Also,
do not forget to increase the sensitivity of the Gsensor in this situation.
Note: Make the DVR an external power source. The built-in battery can provide limited operation
for 2-3 minutes.
TROUBLESHOOTING
1. Why "SD card full" appears on the DVR screen?
• Check if you are using an original Class 10 micro SD card. If you are using Class 4 or 6, the
DVR will indicate "SD card full" because it is not compatible with it. Note: The DVR supports
up to 32GB.
• Check that you have activated the loop recording in the DVR menu. By activating this
function, the old files will be overwritten, and the card will never fill up.
• Verify that you have activated all of these functions: Parking Assistant, GSensor and Motion
Detection. If Gsensor is active, the recording file will be blocked and can not be deleted.
If the parking assistant and motion detection functions are also active, then the DVR will
permanently record until filling the memory.
• Two to three times a month, it's best to format the card to clear it from blocked files that are
no longer useful. Blocked files can also be deleted manually, one by one. They will not be
automatically deleted at the cyclical record.
2. Why the DVR closes and re-opens continuously?
• If the DVR is set to parking mode and Gsensor is on, whenever it detects a touch or shakes,
the DVR will turn on automatically and start recording. When it does not detect any movement,
the DVR will stop.
Recommendation: Deactivate parking functions, Gsensor and motion detection. If the
problem persist, take your device to a service center.
3. Why the DVR blocks the image while recording?
• Check if you are using an original Class 10 microSD card. If you are using Class 4 or 6, the
DVR will indicate "SD card full" because it is not compatible with it, and the screen image
will be blocked.
• If you already use a class 10 card and the problem persists, it could be a firmware problem.
Present the product to a service center or contact the dealer.
4. Why the recorded image is not clear?
• Check the image resolution set in the menu. Options: 1080P, 720P, VGA.
8 User manual