Troubleshooting - BSVILLAGE PISCINE MCC6 Instrucciones De Uso

8. TROUBLESHOOTING

If the suggest solutions do not solve the problem contact your dealer
Problem
Pool Cleaner does not move
The Pool Cleaner moves but
does not clean the pool
The Pool Cleaner cleans
only part of the pool
The Pool Cleaner floats
instead of sitting on the
floor of the pool
Cable has kinks
The Pool Cleaner doesn't
climb the walls
12
-Book_8151255_MCC6-MTC6.indb 12
Solution
1. Check that the power supply is plugged in and turned ON and that the
cable is securely connected all the way into the side of the power supply
2. Ensure the power outlet is functioning properly and that it has not tripped
the breaker in the fuse box
3. Turn the power supply off. Wait 30 seconds then turn it back on
4. Unplug the power supply. Open the impeller cover and check that nothing
is trapped in the impeller
1. Clean the filter bag/cartridge
2. After the Pool Cleaner starts moving observe it for several minutes and
make sure that it keeps moving. If it stops moving check the impeller and
the drive system to see if any debris is stuck there
1. Check that there is enough slack in the cable for the Pool Cleaner to reach
all of the pool
2. Clean the filter bag/cartridge
3. For MCC6 only: push in the float on the cable side (see figure A)
4. Check the brushes to see if they are obstructed or worn out
1. Try removing the air again
2. With the Pool Cleaner in the water squeeze the combined brush/Wonder
brush to make sure that they are completely water absorbent
1. For MCC6 only: push in the float on the non-cable side (see figure B)
2. To remove the kinks stretch the cable out completely and let it sit for at
least a day in the sun
1. Clean the filter bag/cartridge
2. Check the level of the chemicals of the water. Improper levels may allow the
growth of algae making the walls slippery. If so, adjust the levels and scrub
the walls
3. Check that the brushes aren't worn out
4. Check that the wall climbing mode hasn't been cancelled via the remote
control unit (MTC6 only)
Click
A
Robotic Pool Cleaner MCC6/MTC6
Click
B
| User Instructions
15/2/2012 10:48 AM