Installation 8. Safety; General Safety Instructions; Instructions, Standards And Regulations; Appliance Description - wodtke WARMING COMFORT Serie Manual De Instrucciones

iNSTallaTiON • Safety
iNSTallaTiON
8. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
8.1

General safety instructions

We guarantee trouble-free function and operational reliability
only if original accessories and spare parts intended for the ap-
pliance are used.
CaUTiON Burns
- Only mount the appliance on a vertical wall that is
temperature-resistant to at least 85 °C.
- Maintain the minimum clearances to adjacent ob-
jects.
material losses
!
- Never install the appliance directly below a wall
socket.
- Ensure that the power cable is not in contact with
any appliance components.

8.2 Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.

9. Appliance description

9.1

Standard delivery

The following are delivered with the appliance:
- Wall mounting bracket (hooked into the appliance)
10. Installation

10.1 Minimum clearances

≥100
© wodtke GmbH - Tübingen.
≥100 ≥500
≥20
WK01_BA_190718

10.2 Installing the wall mounting bracket

The appliance is intended for wall mounting using the wall
mounting bracket supplied. The appliance may only be installed
horizontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient clear-
ance from the floor.
- Use a spirit level if the floor is uneven or sloping.
1 2
a a a
≥224
f Unhook the wall mounting bracket from the appliance.
f Place the centred wall mounting bracket horizontally on the
floor. Mark holes 1 and 2.
f Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f Mark holes 3 and 4 on the installation wall.
f Drill the holes at the 4 markings.
f Secure the wall mounting bracket with suitable fixing mate-
rials (screws, rawl plugs). With the vertical slots, you can com-
pensate for an offset fixing hole.
3 4
≥224
Page 21 / 76
|