Important Safety Information; Before Operating Saw - Remington BRANCH WIZARD DPS-1 Manual Para El Usuario

SAVE THESE INSTRUCTIONS
INTRODUCTION
Before operating Pole Saw, make certain you read
and understand all Important Safety Information.
IMPORTANT SAFETY
INFORMATION
WARNING: When using an electric
Pole Saw, basic safety precautions
should always be followed to reduce the
risk of fire, electric shock, and injury to
persons, including the following:
READ ALL INSTRUCTIONS.
Make sure you read and understand all
instructions in Important Safety Informa-
tion on pages 2 through 4. Improper use
of this Pole Saw can cause severe injury
or death from fire, electrical shock, body
contact with moving chain, or falling wood.

BEFORE OPERATING SAW

1. Read and understand Pole Saw manual before
operating Pole Saw.
2. Watch what you are doing. Use common sense.
Do not operate Pole Saw when you are tired.
3. Use Pole Saw for cutting wood only. Do not use
Pole Saw for purpose not intended. Do not use
for cutting non-wood items.
4. Only well-instructed adults should operate Pole
Saw. Never allow children to operate Pole Saw.
5. Use only electrical voltage noted on model plate
of Pole Saw.
6. Use only extension cords marked for outdoor use.
See Operating Pole Saw section extension cord
requirements.
7. Do not operate Pole Saw
• while under the influence of alcohol, medica-
tion, or drugs
• in rain or in damp or wet areas
• where highly flammable liquids or gases are
present
• if Pole Saw is damaged, adjusted wrong, or
not fully and securely assembled
• if trigger does not turn Pole Saw on and off.
Chain must stop moving when you release trig-
ger. Have faulty switch replaced by authorized
service center (see Technical Service, page 18).
• while in a hurry
• while in tree or on a ladder
• while on aerial booms, buckets or platforms
• during high wind or storming weather
8. Wear snug-fitting clothes when operating Pole
Saw. Do not wear loose clothing or jewelry. They
can get caught in moving saw chain.
www.desatech.com
9. Wear the following safety gear when operating
Pole Saw:
• heavy-duty gloves (wear rubber gloves when
working outdoors)
• steel-toed safety footwear with non-skid soles
• eye protection such as safety glasses, goggles,
or face screen
• safety hard hat
• ear mufflers or ear plugs
• hair covering to contain long hair
• face or dust mask (if working in dusty areas)
10. Before cutting, always provide the following:
• clear work area
• secure footing
• planned retreat path from falling limbs
11. Inspect tree before trimming. Make allowance
for branches to fall freely to the ground.
12. Do not use your Pole Saw to fell saplings.
13. To reduce the risk of electric shock, this Pole
Saw has a polarized plug (one blade is wider
than the other). This plug will fit in the polar-
ized outlet of an extension cord only one way.
If the plug does not fit fully in the outlet of your
extension cord, reverse the plug. If it still does
not fit, a polarized extension cord will be nec-
essary. If the polarized plug of the extension
cord does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not
change the plug in any way.
WHILE OPERATING POLE SAW
1. Stay alert. Use common sense while operating
the unit.
2. Keep work area clean. Cluttered areas invite in-
juries.
3. Be aware of extension cord while operating Pole
Saw. Be careful not to trip over cord. Keep cord
away from chain and operator at all times.
4. Keep children, animals, and bystanders away
from Pole Saw and extension cord. Only Pole
Saw user should be in work area.
5. Do not use the Pole Saw to cut down trees.
6. Do not use near power lines. Keep at least 10
feet away from electrical lines.
7. Grip Pole Saw securely - one hand on the pole,
the other on the handle.
8. Keep finger off trigger until ready to make cut.
9. Before starting Pole Saw, make sure chain is not
touching anything.
10. To guard against electrical shock, avoid body
contact with grounded objects such as pipes,
fences, and metal posts.
11. Keep all parts of body away from chain when
Pole Saw is running.
12. Do not force Pole Saw while cutting. Apply light
pressure. It will do the job better and safer at the
rate for which it was intended.
2
111607