Wall clock
A. To start the clock
Open the battery cover and insert 1x AA battery according to the polarity indications.
B. Set Time
Turn the hour/minute button in clockwise
C. Adjust Seconds
Remove the battery to stop the second hand. Insert the battery again to restart the second hand on the
correct time.
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos, brands or brand logos and product names are trademarks or registered trademarks of their
respective holders and are hereby recognised as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
Wanduhr
A. Die Uhr in Betrieb nehmen
Öffnen Sie das Batteriefach und legen Sie 1x „AA" Batterie mit der Polarität wie im Batteriefach
angezeigt ein.
B. Einstellen der Zeit
Drehen Sie den großen Zeiger im Uhrzeigersinn
C. Sekunden einstellen
Entfernen Sie die Batterie um den Sekundenzeiger zu stoppen. Setzen Sie die Batterie wieder ein um
den Sekundenzeiger mit der richtigen Zeit zu starten.
ENGLISH
To reduce risk of electric shock, this product should ONLY be
opened by an authorised technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
DEUTSCH
2