Maintenance - GGP ITALY BLV 48 Li Manual De Instrucciones

ASSEMBLY / MAINTENANCE
OPERATING AS A BLOWER
Hold the blower firmly. Sweep from side to side with the
nozzle several inches above the ground or floor. Slowly
advance the unit, keeping the accumulated pile of debris
in front of you. Most dry blowing operations are better
suited to low speeds, rather than high. High speed
blowing is a better way to move heavier items like large
debris or gravel.
OPERATING AS A MULCHER
Hold the vac firmly, tilting the mulcher tubes (2-4 in. or
5-10 cm), and use a sweeping action to collect light
debris. The debris will flow into the bag. Items such as
small leaves and twigs will be mulched as they pass
through the fan housing. For longer bag life and
increased performance, empty the bag often.
CLEANING THE COLLECTION BAG
■ Empty the collection bag after each use to avoid
deterioration and obstruction of the air flow which
will reduce the performance of the unit.
■ Clean the collection bag as needed. With eye
protection on, turn the dust bag inside out after initial
emptying and vigorously shake out the dust and
debris.

6. MAINTENANCE

WARNING
When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc. come
in contact with plastic parts. They contain chemicals
that can damage, weaken or destroy plastic.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with this tool.
Any such alteration or modification is misuse and
could result in a hazardous condition leading to
possible serious personal injury.
CLEARING A BLOCKED TUBE /IMPELLER
WARNING
To avoid serious personal injury, be sure the unit is
OFF and unplugged before clearing the impeller.
WARNING
To avoid serious personal injury, always wear gloves
to protect yourself from the impeller blades or other
sharp objects.
1. Press the on/off (
come to a complete stop.
2. Remove the battery pack.
3. Remove the blower tube or mulcher tubes and the
bag.
4. Carefully remove material blocking the tube or
impeller. Inspect the blades to ensure no damage
has occurred. Rotate the impeller blades by hand to
ensure the blockage is completely cleared.
5. Reinstall the blower tube or mulcher tubes and the
bag.
6. Insert the battery pack into the unit.
WARNING
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or
performing any maintenance.
STORING THE BLOWER
Clean the blower thoroughly before storing. Store the
blower in a dry, well-ventilated place that is inaccessible
to children. Keep away from corrosive agents such as
garden chemicals and de-icing salts.
■ Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery pack life.
■ Never store batteries in a discharged condition. Wait
for battery pack to cool and fully charge immediately.
■ All batteries gradually lose their charge. The higher
the temperature, the quicker they lose their charge.
If you store your unit for long periods of time without
using it, recharge the batteries every month or two.
This practice will prolong battery pack life.
EN
) button and wait for the unit to
6