Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tools and Parts
Gather the required tools and parts before starting installation.
TOOLS NEEDED:
¹⁄₂" Socket wrench or nut
driver
¹⁄₂" Wrench
PARTS SUPPLIED:
Rigid casters (2)
Swivel casters (2)
⁵⁄₁₆–18 Self-locking
hex-nuts (16)
⁵⁄₁₆–18 x ⁷⁄₈"
Hex-head bolts (16)
Unpack Casters
Depending on your model, the casters may be packed in either the
upper or lower compartment. Remove the box containing the
casters.
2
CASTER SAFETY
Your safety and the safety of others are very important.
INSTALLATION INSTRUCTIONS
³⁄₈" Socket wrench or nut
driver
¹⁄₄–20 x 1¹⁄₄" Self-tapping
hex-head bolts (4)
¹⁄₄–20 x 1¹⁄₄" Lock washers (4)
Caster brackets (located in
FeaturePak) (2)
Plastic skids (shipped with
the refrigerator/freezer)
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Install Casters
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator/freezer.
Failure to do so can result in back or other injury.
NOTE: Install the casters before you install any of the FeaturePak
items.
1. Open the lower compartment door and remove the base grille.
Remove the grille by grasping the grille with both hands, lifting up
and pulling bottom of the grille toward you.
2. Place the plastic skids (shipped with the refrigerator/freezer) on
the floor at least 3 ft (91.44 cm) apart. Lay a piece of cardboard
or other protective material over the skids. This will elevate the
refrigerator/freezer to allow for easier caster installation and also
protect it from scratches.
NOTE: If the skids have been discarded or are not available,
2" x 4" boards may be used.
Publicidad
Tabla de contenido
