Maxspect Aeraqua Duo AD600 Manual De Usuario página 11

Switch between Modes
Auto Mode: There are at most 8 time points for you to set
different working speeds which will be recycled every 24hrs.
Manual Mode: Manually set the working speed of the pump.
Manual Mode
1.
Enter setup page.
3. Save the setting.
Note: Leave without operation for 30s will also save the setting.
Auto Mode
1.
Enter setup page.
3.
Set parameter.
Note: Leave without operation for 30s will also save the setting.
Feed Mode
Overflow Detection
position, the pump will recover to the previous working status. "Full" diapears. LED
Logo is constant on.
Current working speed.
Working speed indicator.
2.
Current duration.
Current working speed.
2.
4.
1.
Enter/Exit the Feed Mode.
3. Switch between settings.
5.
Save the setting.
Overflow Warning: Pump turns OFF immediately when the buoy
of the sensor is floating on the water, "FULL" shown on the
display, LED Logo flashing on the controller. Sensor starts to
detect in 10s interval.
Back to Operation: If the buoy is back to its normal
Operation
Set parameter.
Current time.
Working speed indicator.
Switch between settings.
Save the setting.
2.
Enter setup page.
Set parameter.
4.
Buoy
EN
9