Scope Of Delivery; Intended Use; Installation And Connection - Pontec PondoSkim 12 V Instrucciones De Uso

Scope of delivery

 A PondoSkim 12 V
Quantity
1 1
2 1
3 1
4 1
5 1
6 1
7 1

Intended use

PondoSkim 12 V, referred to as "unit", may only be used as specified in the following:
• For surface cleaning of garden ponds, swimming ponds and pools.
The following restrictions apply to the unit:
• Operate in accordance with instructions.
– The table with the data is at the end of the instructions for use.
• Never use the unit to convey fluids other than water.
• Adhere to the required water values depending on the type of water used.
– The table with the data is at the end of the instructions for use.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.

Installation and connection

 B, C
• Install the transformer at a minimum safety distance of 2 m from the water.
• Connect the connection cable of the skimmer to the socket on the transformer and hand-tighten the union nut.
• Place the skimmer into the pond and submerge it until the container is completely flooded.
• To anchor the skimmer, fasten one or two cords to the lugs of the pump chamber and anchor the other ends to the
edge of the pond.
Commissioning/start-up
N O T E
Never allow the pump to run dry. Otherwise the pump will be destroyed.
• Ensure that the pump is always flooded during operation.
• Regularly check the water level.
• Switching on: Insert the power plug into the socket.
– The unit switches on immediately.
• Switching off: Disconnect the power plug.
Description
Skimmer housing with floating aids
Float container
Filter basket
Foam filter
Pump chamber with pump
Pump
Transformer
- EN -
11