DRIJA MILAN 60 Manual De Instrucciones página 41

gas adustment
1
Injector
2
Adjustme n n t of minimum l e e vel of the flam e e
injector in place.
Tu u rn the taps down to minimum
R R emove the knob from the tap and place a small
Control handle bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
Tap
For butane propane gas, the adjusting screw
Sealing ring ‐
must be tightly screwed in.
Refit the control knob.
‐
‐
M
turning
does then remove the control knob and make further
adjustments to the gas flow, testing it again once the
adjustment has been made.
Repeat this process for each one of the gas taps.
/
ake sure that the flame does not go out by quickly
from maximum flow to minimum flow. If it
GB-18