Technical Specifications - Hudora Laufrad Toddler Instrucciones De Montaje Y De Uso

INSTRUCTIONS ON ASSEMBLy AND USE
EN
CONGRATULATIONS ON PURCHASING yOUR PRODUCT!
Please read these instructions carefully. The instructions are an integral
component of the product. Therefore, please store them and the packaging
carefully in case questions arise in the future. Please always include these
instructions when giving the product to a third party. This product must be
assembled by an adult. This product is not designed for industrial use. The
use of the product requires certain capabilities and skills. Always adjust
according to the age of the user and use for the purpose it has been designed
for.

TECHNICAL SPECIFICATIONS

Item:
Item number:
Handlebar height adjustable:
Saddle height adjustable:
Maximum carrying capacity:
If you have assembly problems or would like further information on the pro-
duct, we have all you need and more at http://www.hudora.de/.
CONTENTS
1 x Frame with rear wheel
1 x Front wheel fork
1 x Handlebars
1 x Handlebar pad
1 x Saddle
1 x Front wheel
1 x Spanner
2 x Washer
1 x These instructions
Other parts which may be included with the delivery in some circumstances
are not required.
SAFETy INSTRUCTIONS
• This product is only suitable for smooth paved surfaces. Do not use it on
public roads.
• The running bike is only intended for use by one person.
• Warning! Please ensure that your child wears the appropriate protective
clothing (helmet).
• Warning! The running bike is not equipped with a breaking system since
feet provide the motion power to the driving wheels. Therefore, it is
necessary to wear shoes while using the bike. There is a risk of injury.
• Do not allow your child to ride the running bike at twilight, at night or in
poor visibility.
• To prevent putting your child or others in danger, you should not let the
running bike be used on roads or thoroughfares or on slopes or hills.
Avoid using it in the proximity of stairs or open water.
• Inspect the running bike before each use to ensure that all parts are still
fixed in place correctly and that the running bike is functioning as inten-
ded.
• This product contains small parts which could cause asphyxia if swallo-
wed. Supervise children during the assembling. This product must be
assembled by an adult. Children should only use the product when they
are under adult supervision.
• Please ensure that your child keeps both hands securely on the handle-
bars in order to maintain better control over the bike.
• The use of the product requires specific skills and knowledge to be able
to avoid injury to the user and third parties through a crash or collision.
• Warnings! Protective equipment should be worn. Not to be used in traffic.
35 kg max.
• Recommended for children from 18 to 48 months of age only.
All images are examples of the design.
Toddler walker bike
10340
from 44 - 48 cm
from 29 - 33 cm
35 kg
ASSEMBLy INSTRUCTIONS (DIAGRAM 1 - 5)
1. Put the front wheel into the fork and tighten thenuts. Make sure the hooks
in the lock washers are in their intended holes in the fork.
2. Push the fork from below through the frame, as shown in the diagram 2.
Make sure there is a plastic disc above and below the frame shaft.
3. Push the covering cap over the handlebar shaft. Then push the handlebar
clamp onto the fork shaft from above. Make sure that the handle clamp fits
exactly onto the fork shaft and is pushed down as far as possible. Check
that the rings and the guide sleeves are fully fitted into the frame. Now
insert the handlebars into the fork shaft from above. In order to set the
handlebars at the highest position, the vertical handlebar shaft can be
pulled out to the "MAX" indication. Do not pull out the shaft further as this
might lead to accidents. Make sure that the handlebar shaft is fixed in
correct alignment with the front wheel before screwing the handlebars
tightly into place.
4. Push the covering cap over the handlebar clamp.
5. Insert the saddle into the seat post. Make sure that the maximum seat
height is not exceeded, i.e. do not pull the seat post out beyond the MAX
marking, as exceeding the maximum seat height may lead to serious in-
jury.
6. Finally, fasten the handlebar pad with the Velcro straps to the handlebar.
MAINTENANCE AND STORAGE
Use a dry or damp cloth only to clean the product; do not use special cleaning
agents! Check the product for damage or traces of wear and tear before and
after each use. Do not make any structural changes. For your own safety,
please use original spare parts only. These can be sourced from HUDORA. If
parts become damaged or if sharp edges or corners should develop, the
product may not be used any more. If in any doubt, please contact our ser-
vice team (http://www.hudora.de/service/). Store the product in a safe place
where it is protected from the elements, cannot be damaged, and cannot
injure anyone.
DISPOSAL ADvICE
At the end of the product's life, please dispose of it at an appropriate collec-
tion point in your area. Local waste management companies will be able to
answer your questions on this.
SERvICE
We make every effort to deliver faultless products. If faults do arise however,
we put just as much effort into rectifying them. You can find numerous infor-
mation on the product, replacement parts, solutions to problems and lost
assembly manuals at http://www.hudora.de/artnr/10340.
4/8