SCHÜTTE JAVA 60043 Instrucciones De Montaje página 23

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Disposal
Your washbasin tap is delivered in a solid pa-
ckaging, in order to protect it against transport
damages. The packaging consists of recyclable
materials. Dispose it in an environmentally
suitable manner.
Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.
Note: A 23 mm spanner is required for the
installation of the shower hose.
Please do not use a pipe wrench!
Technical data
Overhead shower: Approx. 30 cm
Shower bar:
Shower hose:
Thermostatic showermixer
• Flow pressure: recommended 1.5 bar; install a
pressure reducer at more than 6 bar
• Water temperature: max. 80 °C
• Water connection:
warm - left / cold - right
Installation Instructions
• Shut off the water supply before beginning
installation
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incorrect
installation - in particular for subsequent
damages!
Approx. 95 - 140 cm, metal
Approx. 150 cm,
kink-resistant, metal,
1/2" (Ø approx. 1,9 cm)
standard connection
 Shower settings
Use the diverter (14.2) to set which shower
mode is activated (overhead shower (6) or
hand shower (7)).
The slope of the overhead shower can be
set as desired by the user.
Instructions for care
Sanitary taps require special care. Therefore,
please observe the following instructions:
• Chrome-plated surfaces are sensitive to lime-
dissolving agents, acidic cleaning agents and
all kinds of abrasives.
• Never clean coloured surfaces with abrasive,
corrosive, or alcoholic agents.
• Only clean your taps with clear water and a
soft cloth or a shammy.
Surface damage is to be expected, if the care
instructions are not observed. This makes any
warranty claims invalid.
Maintenance
• Please note that a valve top is a wearing part
and that in the case of very hard or soiled
water the valve must be replaced every 1 to
2 years, as required. Please purchase spare
parts from your local retailer.
• Please check all joints and connections for
leaks or visible damages at regular intervals.
• In case of any leaks or visible damages to
the fitting or connection hoses, these should
be immediately checked by a specialist and
replaced if necessary.
Decommissioning
• Cut off the water supply before dismantling
the product.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido