Orbegozo HU 2050 Manual De Instrucciones página 13

HU 2050
CARE AND MAINTENANCE
− Switch the appliance off and unplug it.
− Wipe the body of the appliance off with a soft damp cloth. If necessary use a little washing-up
liquid.
− Rinse the water tank with clean water after each use. To dry for storage, wipe with a soft clean
cloth.
− Do not use detergents to clean any part of the unit that normally contains water. Detergents can
interfere with the performance of the unit.
− Do not immerse the humidifier in water or any other liquid.
− Do not use harsh or abrasive cleaning agents or solvents.
CHECK THE MALFUNCTION AND REPAIR
If your humidifier can't work, please ask the service department to repair:
MALFUNCTION
1. Power indicator can't work and
with no wind and mist
2.Power indicator illuminate, the
unit with wind but no mist
3.Smelly mist
4.Power indicator illuminate, the
unit with no wind and mist
5.Little mist comes out of the
nozzle
6.Abnormal noise
TECHNICAL CHARACTERISTICS
MODEL
HU 2050
CAUSATION
Didn't connect the power supply
Didn't turn on the humidifier
No water in the water tank
New humidifier
Dirty water or long-time to store
water in water tank
Too much water in the base flume
Dirty ultrasonic transducer
Dirty water or long-time to store
water in water tank
Caused by little water in water
tank.
Resonance from table-board
VOLTAGE /
POWER
FREQUENCY
30W 220-240V ~ 50/60Hz
RESOLVE METHODS
Connect the humidifier from the
power supply
Switch on the unit
Fill water in water tank
Open water tank, put it in shadow
for 12 hours.
Clean the water tank, fill clean
water in.
Empty the flume, then close the
cap of water tank.
Clean the transducer
Clean the water tank, fill clean
water in.
Fill water in water tank.
Place on a stable level surface.
TANK CAPACITY
5.2 L
13