Main Features - Westinghouse WJS001 Manual De Operaciones

G B

Main Features

• Jump start most gasoline engine up to 6.8L (8 Cylinders), most diesel
engine up to 2.5L (4 Cylinders) and most watercraft with 12 volt
ignition systems.
• 2A USB port for everyday charging and powering of tablets, smartphones
and other mobile devices. Great for extra power when traveling!
• 10 levels of safety protection
1. Short Circuit Protection
2. Spark Protection
3. Reverse Polarity Protection
4. Reverse Charging Protection
5. Clamp Looseness Protection
6. Over Voltage Protection
7. Low Voltage Protection
8. Over Temperature Protection
9. Over Current Protection
10. Overload Protection
• Integrated flashlight with 3 light modes (LED remain constant on /flashing /
strobe) provides illumination and safety during roadside emergencies.
• Portable, compact and light weight design, convenient for daily use or store
in glove box or door pocket.
• LED power-level indicator
• USB Car Charger: 2.4A USB charging port for fastest possible charging.
To Charge the Jump Starter
1. Connect one end of the included Micro USB cable to the Jump Starter &
Mobile Power and the other end to any powered USB device to begin
charging.
2. Blue light flashing indicates charging is in progress.
3. Charging is completed when five status lights are lit (not blinking).
NOTE: Charge the Auto Jump Starter & Mobile Power every three months
to be sure your Jump Starter will be ready when you need it.
WJS001 Manual 英法西中.indd 6-7 WJS001 Manual 英法西中.indd 6-7
*USB Wall Charger is not included
2
To Jump Start a 12 Volt Vehicle
Check the LED power indicators on the side of the unit. A minimum of 3
illuminated LEDs is required to jump start a vehicle. A fully charged unit
is recommended.
1
Connect the red Jumper Clamp
to the positive (+) terminal on the
car battery, and the black Jumper
Clamp to the negative (-) terminal.
3
Start the vehicle once the green
light on the Jumper Cable remains
co n st a n t . Af te r t h e ve h i c l e i s
started, disconnect the Jumper
Cables from the Jump Starter.
NOTE: If the vehicle will not start after four consecutive attempts, the
red LED on the Jumper Cable will light on, check the power status of the
Jump Starter (A minimum of 3 illuminated LEDs is required to jump start
a vehicle) or consult a mechanic. To ensure a good performance under
extreme cold condition, the product temperature must be above 0°C /
32°F.
To Use the LED Function
1. Press and hold the power switch
button for 3 seconds until the
LED light glows steadily.
2. Press the power switch button to
.
cycle through flashing strobe and
to turn off light.
GB
2
Connect the Jumper Cable to the
12V Jump Starter outlet on the unit.
4
Remove the Jumper Clamps from
the vehicle's positive and negative
terminals.
3
2015/8/25 17:18:36 2015/8/25 17:18:36