Connecting The Lcd Tv To A Pc; Using Side Av Connectors; Connecting To A Dvd Player Via Hdmi; Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable - Saba SBV1943H Instrucciones De Manejo

• Recordings of HD programmes can occupy bigger
size on the USB disk depending on the broadcast's
resolution. For this reason it is recommended
to use USB hard disk drives for recording HD
programmes.
• Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
• Multipartition HDDs are supported until two
partitions.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.

Connecting the LCD TV to a PC

For displaying your computer's screen image on your
LCD TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LCD TV. When the connection
is made, switch to PC source. See "Input selection"
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts
PC VGA Cable
(Not supplied)
PC Input
(back)
Side Audio/Video
Connection Cable
(Supplied)
Side AV Input
.

Using Side AV Connectors

You can connect a range of optional equipment to your
LCD TV using side connectors of the TV.
• For connecting a camcorder or camera , you should
use AV socket (side). To do this, you must use the
supplied video/audio connection cable. First, plug
single jack of the cable to the TV's AV IN socket
(side). Afterwards, insert your camera cable's (not
supplied) connectors into the plural part of the video/
audio connection cable. Colours of the connected
jacks should match. See illustration below.
• Afterwards, you should switch to
the section Input selection in the following sections
for more information.
Or
PC Audio Cable
(Not supplied)
Side AV source. See
English - 53 -
• To listen the TV sound from headphones, you
should connect headphones to your TV by using the
HEADPHONE jack as illustrated above.

Connecting to a DVD Player via HDMI

Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player via
Component Sockets (YPbPr) or
Scart Cable
• Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
• When the connection is made, switch to YPbPr
source. See, "Input selection" section.
• To enable audio connection, use the
Component Audio cable. First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player's audio cable's connectors into the plural part
of the VGA/Component audio connection cable
(see illustration below). Colours of the connected
jacks should match ( RED & WHITE).
HDMI socket, you can
HDMI Cable
(not supplied)
External device
VGA/