Quick Start Guide; Diaper/Nappy Fitment - Snuza Go Manual De Instrucciones

4. QUICK START GUIDE

1. Important: Use the correct diaper size and make sure it fits snugly (see
Section 5 Diaper/Nappy Fitment).
2. Switch on by briefly pressing the ON/OFF button (5).
3. A start-up test will illuminate the indicator lights, play the start-up tone and
perform a battery test.
4. Clip Snuza Go! onto the diaper so that the Movement Sensor (1) is in direct
contact with the baby's skin in the tummy area (see Section 6 Fitting your
Snuza).
5. The Movement Indicator Light (3) flashes on each movement. See Section
7.2 Monitoring for a full description of what it signifies.
6. If no movement is detected for a period of 20 seconds, the full audible
alarm will sound and the Movement Indicator Light (3) will flash red. See
Section 8.2 Alarm Activation Period for a description of how to reduce the
time period to 15 or 18 seconds.
7. The alarm can be deactivated by briefly pressing the MODE/OFF button (6)
and monitoring will continue.
8. To turn off the monitor, press both the ON/OFF (5) and MODE/OFF (6)
buttons simultaneously. A shutdown tone will be heard.

5. DIAPER/NAPPY FITMENT

Important: Correct diaper fitment is essential for the
operation of Snuza. The thin flap of material at the top
of the diaper must be folded over the thicker part before
the diaper is closed (this is the section to which Snuza
Go! will be attached). The diaper should fit snugly on the
baby with the top of the diaper just below the belly
button. Loose fitting diapers will gape, causing the
monitor to lose contact with the baby and false alarm. A
very 'full' or wet diaper may also cause it to gape.
8