Using The Dc Kit; Switching On The System - Dometic DC-Kit4 Instrucciones De Montaje

Using the DC Kit

8 Using the DC Kit
The DC-Kit4 consists of several components, each with its own installation and
operating manual. Use the installation and operating manuals for the components
and make sure you are familiar with the individual devices.
This chapter contains information on operating the overall system. This operating
manual does not replace any information contained in the installation and operating
instructions for the components.
A
NOTICE!
B3200, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200: The inverter
may be damaged.
Ensure that these models are not used in the air conditioning or heating
modes for driving. The inverter is not designed for generating this
amount of power.
A
NOTICE!
B3200, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200: The inverter
may be damaged.
If you are operating the system on the 230 V mains and the automatic air
conditioner or the heating is on, make sure that the inverter is switched
off and stays switched off.
The inverter is not designed for the amount of power an activeheating
system requires. If the 230 V mains power fails, the inverter would then
take over supplying the power.
8.1

Switching on the system

Observe the following instructions before you switch on the system:
• Air the vehicle.
• Make sure that the ventilation slots on the air nozzles and the fan of the
components are not covered up.
• Make sure that all the housings and cables are not damaged and that all the
insulation is intact.
• Compare the existing supply voltage with the technical data.
• Do not insert any fingers or objects into component openings.
14
DC-Kit4
EN