To Prepare The Product For Long-Term Storage - Husqvarna G1300P Manual De Usuario

Problem
Engine backfire occurs.
The product has no power.
The product does not operate cor-
rectly.
CAUTION:
servicing dealer if the problem stays.

To prepare the product for long-term storage

Do the steps that follow if the product will be kept in
storage for more than 30 days. The procedure that
follows prevents problems with the fuel system.
1. Add a fuel stabilizer to the fuel. The fuel stabilizer
must agree with the recommendation from the
manufacturer.
2. Operate the product for 10-15 minutes.
3. Let the engine become cool and drain the fuel tank.
CAUTION:
term storage. Discard gasoline that is not
clean.
4. Start the engine and let it operate until all the fuel
has been used and the product stops.
5. Let the engine become cool and replace the engine
oil.
6. Remove the spark plug cap and put ½ oz/15 ml of
engine oil into the cylinder.
14
Cause
Low quality gasoline.
The engine is too cold.
The inlet valve is blocked or the en-
gine is too hot.
Incorrect ignition timing.
The product is not connected to the
electrical source.
A circuit breaker has tripped.
The receptacle is engaged.
Servicing is necessary.
Problem with an electrical device.
There is too much load in the prod-
uct.
Speak to an approved
Do not keep fuel in long-
Solution
Fill fuel.
Use fuel for cold conditions and oil
additives.
Speak to an approved servicing deal-
er.
Do a check of the ignition timing.
Stop the product and disconnect it.
Connect the product and start it
again.
Stop the product and disconnect it.
Restart the circuit breaker. Connect
the product and start it again.
Stop the product and disconnect it.
Do a test of the receptacle. If the re-
ceptacle is not damaged, start and
connect the product again.
Speak to an approved servicing deal-
er.
Disconnect the electrical device.
Speak to an approved servicing deal-
er.
Decrease the quantity of electrical
devices connected to the product.
7. Put a cloth on the spark plug hole for protection.
8. Pull the starter rope handle 5 times to lubricate the
engine parts.
9. Install and tighten the spark plug.
WARNING:
plug cap.
10. Clean the product.
11. Put the product in a clean and dry location indoors.
12. Put a cover on the product for protection.
WARNING:
the product if it is warm.
Do not install the spark
Do not put a cover on
1420 - 003 - 09.07.2020