3 Tec 3920 Instrucciones De Uso página 7

15. Attaching the hood to the cot bumper
Fasten the four press studs on the bottom of the hood onto the
bumper.
16. Fitting the adapter to the carrycot
Fit the adapter onto the carrycot from below until it engages in the
brackets provided.
Make sure that the adapter is securely engaged.
17. Inserting the mattress
Insert the mattress in the cover.
Lay the mattress on the base.
NB: The mattress is wedge-shaped. Make sure that the raised
part is at the head end.
18. Adjusting the handle
To adjust the handle, press the buttons on both sides.
Now you can adjust the handle.
19. Fitting the apron
Fit the closed end of the apron over the lower end of the carrycot.
Extend the apron over the cot.
Secure the ends of the apron with the Velcro fastening provided on
the outside of the hood
EN - 12
20. Mounting the carrycot on the pushchair
The adapter is fitted to the long side of the carrycot.
Place the carrycot onto the pushchair so that the catch mechanism
engages.
To remove the carrycot, press the buttons on the adapter on both sides
of the cot and lift the cot up to release it from the catches.
15
CAUTION: Always check before use that the carrycot is correctly
secured to the pushchair.
21. Adjusting the bar-type handle
Press and hold down the button on the bar-type handle and set to the
required height.
16
22. Folding the pushchair
Press the round button (1) on the right-hand release catch in order to
17
unlock the folding mechanism.
Then pull both release catches (2) up and lower the handle.
Pull the two release catches on the front fork backwards and lower
the fork inwards.
18
Note: To unfold the pushchair, follow the instructions in point 1
"Opening the pushchair".
19
20 20
21
22 22
22
EN - 13