Troubleshooting - OK. OVC 3114 A Manual De Instrucciones

En
Changing of the dust bag
Fig. 11 If the dustbag fill indicator shows red or if the suction power diminishes, the dust bag must
be changed and the filters must be cleaned.
Open the lid and remove the dust bag by taking it out of the dust bag holder.
Insert a new dust bag into the dust bag holder and close the lid.
Cleaning the motor filter
Remove the motor filter and tap it to remove the dust. Then re-insert it. Insert the filter in the
Fig. 12
right direction so that the correct side is facing the motor. The side which faced the dust bin
before should not face the motor when re-inserting it again.
Warning: Never use the vacuum cleaner without a motor filter, as otherwise, the motor will
soon get dirty and will be subject to wear. If the motor filter gets dirty, the suction power will
diminish.
Reassemble all of the components that have previously been removed. Assembly is carried
out in reverse order.
Cleaning the exhaust air filter
Open the flap, take the filter out and tap it to remove the dust. Assembly is carried out in
Fig. 13
reverse order.

TROUBLESHOOTING

If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem
Product does not work
Product cannot absorb dust or
loose suction power
SPECIFICATION
Rated voltage
Rated power input
Protection class
• This is a general purpose vacuum cleaner
• The Erp test method is according to (EU) No 666/2013 +Amd. (EU) 2016/2282; (EU) No 665/2013
+Amd. (EU) 2017/254; EN 60312-1:2017; EN 60704-1:2010/A11:2012 & EN 60704-2-1:2015
• Please refer to below website for detail technical information, or contact the manufacturer for
technical document: www.ok-online.com
DISPOSAL
The crossed-out wheeled bin logo requires the separate collection of waste electric and
electronic equipment (WEEE). Electric and electronic equipment may contain dangerous and
hazardous substances. Do not dispose of this appliance as unsorted municipal waste. Return it
to a designated collection point for the recycling of WEEE. By doing so, you will help to conserve
resources and protect the environment. Contact your retailer or local authorities for more
information.
IM_OVC3114A_180103_V05_HR.indb 10
10
Possible causes
• Interrupted power supply
• Filters are blocked with dirt
• Dust container full
• Suction hose/ telescopic tube
blocked with dirt
: 220 - 240 V~ 50/60 Hz
: 800 W
: II
Solution
• Check the power supply
• Clean and wash the filters
• Empty the dust container
• Clean and wash the suction
hose/telescopic tube
3/1/18 6:28 pm