Product Disposal - BATSI MIE210ACC Manual De Uso

INTRODUCTION
This instruction manual has been written by the controller manufacturer and is an exclusive part
of the product. The operations contained are addressed to properly trained and qualifi ed per-
sonnel. It is recommended to be read and stored for future reference.
TERMS OF USE
BATSI® recommends the installation of all devices, equipment and materials, complying with
European Directives 2006/42 / EC (Machinery Directive), 2014/30 / EU and subsequent modifi ca-
tions (low voltage electrical equipment). Non-EU countries, in addition to existing national stan-
dards and for a suffi cient level of safety, it is also recommended to comply with the indications
contained in the above Directives.

PRODUCT DISPOSAL

In accordance with the EU Directive 2012/19 / EU on Waste Electrical and Electronic Equipment
(WEEE), this electronic product can not be disposed of with other unclassifi ed waste. Dispose of
this equipment by returning it to a local collection point for recycling.
MIE210ACC MODULE OPERATION
The MIE 210ACC module is used as an action counter, so it counts how many times an action is
performed, using a sensor that can be PNP or NPN.
The controller has a partial action counter (to control the actions performed on a plot of land for
example) and another counter for the total actions (to control actions performed throughout
the day).
Both counters can be reset when desired. The controller also has a "buzzer" that will beep each
time an action is detected. This buzzer can also be deactivated using the menu.
CHOOSE DATA TO MODIFY
To select a data to be modifi ed (counter, enable / disable buzzer), make sure that the desired
data is indicated by an arrow (<--) on the right side of the screen. To select the data, you must
press the button with a short press to scroll through the menu.
Short pulsation Short pulsation
4