Speedlink FULL METALL 5.1 SYSTEM Instrucciones De Manejo página 14

Functions of the remote control:
Note: The sensor for the infrared remote control is located in
GB
the centre speaker. Always direct the remote control towards
the centre speaker to adjust settings. Apart from the "Power"
button, all other commands are indicated by the flashing of the
LED on the centre speaker.
Power:
Press the "Power" button to switch the system on/off.
The system goes into standby mode when switched off. To
switch the system off completely, press the switch on the front
of the subwoofer.
Mute:
Press the "Mute" button to switch the system sound off. Press the button again to
switch sound on again.
Volume: ▲ / ▼
Press the arrow buttons to adjust the overall volume.
Rear/Center/Bass
Use the "+" and "-" buttons to adjust the output of the rear speakers, the centre
speaker and the bass.
Default Settings
Press the button to re-establish the standard settings.
Virtual Surround On/Off:
The Virtual Surround button allows you to reproduce stereo sound via the front
speakers and subwoofer. Deactivate this function ("Off") when you connect a 5.1
sound source.
15