Connecting The Device; Starting The Xploview Software - Reflecta DigiMicroscope Flex Manual De Instrucciones

Connecting the device

Connect the device to the computer using the USB cable provided.

Starting the xploview software

Windows based PC
The xploview software can be launched by double clicking the xploview icon
< > from the desktop, or from the start menu.
Mac OS based PC
The xploview software can be launched by double clicking the xploview icon
< > from the Applications menu.
When the device is connected to the computer for the rst time, a driver
will automatically be installed by Windows or Mac OS. This process could
take up to a few minutes.
Each time when the xploview software is started, the device should start up
automatically. Otherwise, the device can be selected from the device setup
section of the system settings menu.
It is normal that the LED will ash once when the device is plugged in. When
xploview is running, the LED will switch on again automatically.
10