Delay Function; Remote Control - Beper RI.063 Manual De Instrucciones

Wall-mounted fan heater with ceramic elements Use instructions

DELAY FUNCTION

This function can only be activated with the remote control.
The product can be switched off and switched on automatically, in this way the product will remain in
"Stand-by" mode and it will not be possible to switch it on and off with the "ON / OFF" button.
Press the "LOCK" button and then press the "DELAY" button once so the "DELAY" and "I / W" indi-
cators will light up. Use the "+/-" keys to set the delayed start time from 0 to 24. For example if you
set 4 means that the product will start to work after 4 hours.
By pressing the "DELAY" key again the "DELAY" and "I / W" lights will light up, use the "+/-" keys to
set the off time from 0 to 24. For example if you set 7 means that the product will automatically shut
off after 7 hours. So it will work for 3 consecutive hours.
Attention: When the "DELAY" key is pressed the number fl ashes for 5 seconds, they should be suf-
fi cient to make the selections, otherwise the product will return to standby, and the "LOCK" key must
be pressed to reactivate the product and reset it.
(This setting will be cancelled if there is a power failure).
CHILDREN SAFETY FUNCTION
This function can only be activated with the remote control.
When the product is connected to the electrical outlet by pressing the "LOCK" button once all the
lights will go out, with the exception of the "Power" light. In this way both the remote control and the
control panel will not be operative.
Press the "LOCK" button again and everything will return to active.
CONTROL PANNEL : Fig.2

REMOTE CONTROL

The remote control works with a CR2025 - 3V button battery included.
To make it operative, remove the protective fi lm placed near the battery compartment.
The remote control shows the keys as follows:
1. "ON/OFF" Main power button
2. "24H" Setting timer from 1-24 hours
3. "MODE" COLD,WARM,HOT 3 setting for selection
4. "Swing" Louver swing up and down
5. "LOCK" Child-Lock function
6. "AUTO" Window Open Function
7. "DISPLAY" Display room temperature
8. "Delay" Set the start and stop time of heater
9. "W.Timer" Set the timer of one week
10. "+" Increase
11. "-" Decrease
12. "Set" Set real time
17
EN