Troubleshooting; Directions For Use - Reliable G4 Serie Manual De Instrucciones

HOW TO STEAM CONTINUED...
6. Some garments may react better if they are steamed from the inside.
again. While you can easily store the G4/G4m when not in use (the water
should be drained from the unit if it will be stored for a long period of time)
spot where you will use it the most frequently. For some people that would be

DIRECTIONS FOR USE

tighten until it is snug.
3. The same wrench can also be used for tightening the device that holds the
rod set. The steam head can be placed in the upper portion of the rod set until
it is ready for use.
4. Remove the cap from the water bottle. Fill the water bottle with regular tap
it in the body of the steamer.
NOTE: If rinsing the unit does not improve the performance, the steamer
may require more thorough cleaning. This must be done by an authorized service
center only, or the warranty will be void.
06

TROUBLESHOOTING

semble or attempt to repair the unit on your own. Return the unit to Reliable
PROBLEM POSSIBLE CAUSES
Steamer does not get hot. 1. Steam unit is not plugged
in or turned on.
engaged. The water bottle
is empty and the reservoir
has drained.
The unit is not 1. Water level is too low.
producing steam. 2. Element may not be
functioning.
and cycles on/off. cleaning.
2. The thermostat may be
defective.
The switch light does not
illuminate when the switch is 2. Cord is not good.
turned to the on position. 3. Fuse wire is bad.
4. The outlet may not have
power.
Water drips from nozzle. 1. Condensation has formed
inside the steamer hose.
REMEDY
1. Plug the steamer in.
Turn it on.
2. Push the on/off switch to
the off position. Fill the
place. Turn on.
1. Push the on/off switch to
place. Turn on.
2. Replace heating element.
1. Throw the old water out
2. Replace thermostat.
1. Replace part.
2. Replace part.
3. Replace part.
4. Try plugging into a different
outlet.
1. Hold the hose upright and
base of the unit.
07