This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize
the possibility of electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord
supplied.
The cord should be secured behind the refrigerator and not left exposed or dangling to prevent
accidental injury.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull it
straight out from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Reversing the Door Swing of Your Appliance
Ø
This unit has the capability of opening the door either from the left or the right side. The unit is delivered to you with the
door opening from the left side. Should you desire to reverse the opening direction, please follow the instructions.
Note: Before reversing the door, the power must be shut off. All parts removed must be saved for reinstalling the door.
This unit has been built with the door hinges on the right. If you wish to change the opening direction, follow the
instructions below:
1. Remove the upper hinge cover (6) first.
2. Remove the three screws (1) that hold the upper hinge (5) (right side) to the frame and take away the upper hinge (5)
(right side).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws (8) that hold the lower hinge (2) and make sure to remove the lower hinge (2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the whole cover plate (7) at the right side.
7. Before placing the lower hinge (2), remove the bolt pin (9) and reverse the direction of the lower hinge (2). Then install
the lower hinge (2) onto the left side of the lower frame with the three screws.
8. Insert the bolt pin into the lower hinge (2).
9. Set the door to its place in the lower hinge (2).
10. While holding the door in the closed position, secure the upper hinge (5) to the top frame of the left side with the
three screws. Please remember not to tighten the three screws until the top of the door is leveled with the counter top.
11. Install the upper hinge cover (6) on the upper hinge.
5