Global 246105 Manual Del Usuario página 4

On/Off power supply is used to control the start-up or
shut down of the dehumidifier.
Increase and decrease the indoor humidity level,
or set the time.
• Humidity adjustable range is 35%RH-80%RH. The
screen will display the setting humidity, and after few
seconds, turn to display the ambient humidity.
• When the ambient humidity is lower than the set
humidity, the compressor will stop running and after a
few minutes, the fan will stop running.
• To continuously run, press the
is displayed on the screen and the
symbol lights up.
Fan speed is used to select the speed from Low to
High. Speed is on high when the
Timer button is used to to delay start-up or shutdown.
This avoids wasting electricity by optimizing operating periods.
PROGRAMMING START-UP
• Turn machine on and choose mode; for example:
Dehumidify Mode, High Fan Speed. Turn machine off.
• Press Timer Button, the screen will begin to flash. Press
the buttons to adjust the set-time from 0.5 to
24 hours.
• After 5 seconds without operation, the timer will begin
and the symbol will light up.
• To cancel Timer, press Timer button again and the
will disappear.
CONTINUOUS DRAINAGE
Using Built-In Pump (Model 246108 Only)
Seal Ring
Drain Adapter
• Connect the drain pipe on the
back of the dehumidifier; this will
allow the unit to run continuously
without the use of the bucket.
1. Place the dehumidifier on a level
surface and unscrew the cap on
the back of the unit.
2. Install the drain and gasket connector.
3. Install the drain pipe to the connector.
4. Press Power button to run the
unit. For Model 246108 Pump Drain:
5. Press the "PUMP" button to start the pump drain
function, and the "PUMP" symbol will light up. The
maximum height of pump drainage is 16.4 ft (5 meters).
Energy Efficient Portable
Dehumidifier
button until
continuous
symbol lights up.
Drain Hose
4
BUCKET FULL ALARM
• When the bucket is full, the compressor will shut-off
and after a few minutes the fan will stop. The machine
will begin to beep and the bucket full symbol
will flash.
• The unit will not run again until the bucket is emptied
and properly placed back inside the dehumidifier.
• Clean the bucket weekly to prevent growth of mold,
mildew and bacteria. Use a mild detergent to clean.
Ensure bucket is completely dry before reinstalling
back into dehumidifier.
• NOTE: Hold the bucket with both hands when emptying.
• NOTE: When the bucket is full or removed from the unit,
the compressor will turn off but the fan will continue to
run for a few minutes. This is completely normal; the
machine will not be removing moisture from the air at
this time.
• NOTE: During normal operation, the humidifier will
exhaust warm air from the top of the unit.
• CAUTION: DO NOT place the bucket on the floor when
full as bottom is uneven and may cause spillage.
AUTOMATIC DEFROST
When frost builds up on the evaporator coils, the compressor
will cycle off and the fan will continue to run until the
frost disappears. When the coils are completely defrosted,
the compressor or fan (depending on the model) will
automatically restart and dehumidification will resume.
CONTINUOUS DRAIN HOSE ROUTING
Without Pump (All Models)
1. Connect 1 1 /16 " threaded garden hose (not included)
onto the units drain hole.
2. Make sure hose is installed correctly, otherwise the
water will not drain properly, (see image below).
3. Use gravity to drain water to a nearby drain or other
location.
Correct
• If the continuous drain function is not needed, install the
cap on the drain hole on the back of the unit and the
water will flow into the bucket.
NOTE: Ensure the unit is placed on a level surface,
otherwise the water will not drain properly.
User's Manual
Incorrect