Beper RI.419 Manual De Instrucciones página 11

Electric heating pad Use instructions
It is not advisable to use extension cords, as these may overheat and cause the risk of fire.
Do not use a single extension cord to operate more than one appliance.
Do not touch the plug or the appliance with wet hands.
Avoid using the appliance in dusty environments or in the presence of flammable vapours
(e.g. in workshops or garages).
Do not place the appliance above or near another heat source.
A heating pad contains parts that generate arcs or sparks. Do not use the appliance in
potentially dangerous areas such as areas at risk of fire or explosion, or environments
filled with chemical substances or humidity.
Place the power cord far away from busy areas or places where it can be accidentally pulled-out.
This appliance cannot be used in bathrooms, laundry rooms, next to a shower or swimming pool or
in similar indoor environments. Never position the appliance where it may fall into a bath or other
containers filled with water.
Do not allow the power cord to touch the hot parts when the appliance is in operation, in order to
prevent the heat from damaging the cord.
The cord must be kept far away from heated surfaces.
Do not operate the appliance outdoors. Do not operate the appliance next to an open window.
WARNING: do not operate this appliance with a programmer or any external other device that
automatically turns on the appliance, as this may cause the risk of fire.
Do not attempt to repair, dismantle or modify the appliance: it does not contain parts that can be
repaired by the user.
Turn the switch off and remove the plug before carrying out any maintenance work or moving the
appliance. Always remove the plug from the socket when the appliance is not in use.
WARNING: ALWAYS REMOVE THE PLUG WHEN CARRYING OUT MAINTENANCE WORK OR
MOVING THE APPLIANCE.
If the appliance is not used for prolonged periods, remove the plug, place the product in its box and
store it in a dry,
ventilated place.
WARNING:
THE ON/OFF SWITCH IS NOT THE ONLY METHOD OF DISCONNECTING THE MAINS POWER.
ALWAYS PULL OUT THE PLUG FROM THE SOCKET IN THE EVENT OF MAINTENANCE OPE-
RATIONS, WHEN
MOVING THE APPLIANCE OR WHEN IT IS NOT USED.
11