ECG ED 80 HN Manual De Instrucciones página 31

knowledge, if they are supervised or have been instructed to use
the product in a safe manner and understand the potential dangers.
Children must not play with the appliance. Cleaning and maintenance
operations performed by the user shall not be carried out by children,
if they are not older than 8 years and under supervision. Children under
8 years of age must be kept away from the appliance and its power
supply.
23. Children older than 3 years old may not use the appliance, if the control
is not set by a parent or guardian, or if the child was not sufficiently
instructed how to operate safely the control device
24. The product must not be used as a cushion for pets. There is a danger
of chewing and electric shock, possibly resulting in the death of the
animal.
25. It is bottom blanket, which is intended for placement on the bed and
perhaps covering by a thin bedsheet. The blanket is not intended for
placement under the mattress.
OPERATING INSTRUCTIONS
Notes:
• Use only with control unit ED 80 (blankets ED 80 HN and ED 80 BE)
Use only with control unit ED 140 (blankets ED 140 HN and ED 140 BE)
•
• When the heating blanket is folded, wrinkled, or is used in an inappropriate manner, it can cause
overheating and subsequent activation of permanent protection. In such case it is necessary to send it to
the manufacturer for repair. Do not try to repair the blanket on your own.
• If the grid voltage is lower than the voltage recommended to power the blanket, the temperature will rise
very slowly and the heating capacity will be limited. It is not a malfunction of the heating blanket. Make
sure that the blanket is powered by the recommended voltage.
• The indicator light and the electric circuit of the blanket are connected in parallel. The malfunction of the
indicator therefore does not affect the ability of the blanket to generate heat.
Use only as a heated underpad under the body. Do not use it as a covering blanket, for wrapping or in
•
any other manner.
Preparation
1. Lay the blanket on the bed and make sure that it is not creased or folded.
2. Fasten the blanket to the bed or to the mattress by four tabs in the corners.
3. You can spread over the blanket only a thin cotton bedsheet. Do not cover with a blanket or other material,
which could cause overheating of the blanket and limit the heat transfer.
4. Place the controller so that it could be easily accessible. Make sure that it is not hidden under a blanket or
a pillow, etc. Do not place the controller close to other heat sources, to prevent overheating and damage.
Setting basic temperature:
1. Connect the power cord of the blanket in the electric outlet 220~240 V, 50/60 Hz. Move the switch on the
controller in the position [2]. The control indicator comes on and the blanket starts to heat up. The heating
lasts about 30–50 minutes. You can then move the switch as needed in the position [1] for comfortable
Do not immerse in water!
GB
31