Disposal
Fault
When operating from
the 12/24 V socket
(cigarette lighter):
The ignition is on
and the device is not
working and the LED
is not lit.
Pull the plug out of the
socket and make the
following checks.
The display shows an
error message (e.g.
"Err1") and the appli-
ance does not cool.
10
Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the product, ask your local recycling
M
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
18
Possible cause
The cigarette lighter
socket is dirty. This
results in a poor electri-
cal contact.
The fuse of the 12/24 V
plug has blown.
The vehicle fuse has
blown.
The appliance has
switched off due to an
internal fault.
Suggested remedy
If the plug of your cooler becomes very
warm in the cigarette lighter socket, either
the lighter socket must be cleaned or the
plug has not been assembled correctly.
Replace the fuse (8 A) in the 12/24 V
plug, see chapter "Replacing the plug fuse
(12/24 V)" on page 16.
Replace the vehicle's 12/24 V socket fuse
(usually 15 A). Please refer to your vehi-
cle's operating manual.
This can only be repaired by an
authorised repair centre.
FR35 AC/DC
EN