4.
When using the appliance, keep in mind that the
ceramic plates are very hot.
5.
Make sure your hair is entirely dry before beginning
the styling process.
6.
For easier hairstyling, divide your hair in the middle
or along the sites into multiple segments, and apply
a hairpin to the segments you are not currently
straightening.
7.
Your hair may need brushing to make sure it is not
tangled before straightening.
8.
Divide your hair into layers and begin straightening
from the bottom layers. After the bottom layers have
been straightened, continue with the middle layers
and fi nish the with top layers by the part.
9.
For shorter hair, place a brush in between the head
and straightener to prevent the hot straightener
touching your skin. Do not use the straightener too
close to your skin, ears and neck.
10. Switch the straightener off and disconnect from the
outlet after use.
11. You can fi nish your hairstyling by applying hair
balsam. Rub the balsam in using your palms in
a continuous motion from root to end.
Note: Using lower power is recommended for people
with coloured, brittle, damaged and fi ne hair. To
save time and eff ort, using the maximum amount
of heat, established on the highest setting, is
recommended for people with healthy rough,
strong, exotic and resistant hair.
Userful hairstyling tips
• Straight hair
Insert a lock of hair, approximately 5 cm wide, in between
the ceramic plates, press the handle and slowly slide the
hair straightener from the roots to the ends.
• Fine curls
Insert a lock of hair, approximately 5 cm wide, in between
the ceramic plates, press the handle and slowly slide the
hair straightener from the roots to the ends.
• Outward curls
Insert a lock of hair, approximately 5 cm wide, in between
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into plastic
recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste. Hand
over the product to the specifi ed location for recycling electric and electronic equipment. Prevent negative impacts on
human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product, refer to
your local authority, domestic waste processing organization or store, where you purchased the product.
This product complies with EU directive requirements on electromagnetic compatibility and electrical
safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.
the ceramic plates, press the handle and slowly slide the
hair straightener from the roots and fi nally gently curl the
ends out.
• Inward curls
Insert a lock of hair, approximately 5 cm wide, in between
the ceramic plates, press the handle and slowly slide the
hair straightener from the roots and fi nally gently curl the
ends in.
CLEANING AND MAINTENANCE
•
There are no components for the user to adjust
inside the device, all repairs shall be carried out by
a qualifi ed repair centre!
•
Disconnect the appliance from the electrical output
prior to performing any maintenance.
•
The appliance shall only be cleaned when cool; clean
the appliance regularly after every use.
•
Do not use aggressive cleaning agents or abrasive
substances for cleaning.
•
Maintain the ceramic plates clean, without dust,
impurities, hair gels and sprays. Do not use together
with hair foam, spray, gel etc.
•
Wipe the plates with a damp (not wet) cloth and dry
with a soft dry cloth. Never clean the iron under running
water, do not rinse or immerse the iron into water!
Storage
•
Always make sure the hair straightener is completely
cooled, clean and dry before putting it away.
Hinge lock function
You can store your hair straightener safely with the
ceramic plates pressed against each other and the hinge
locked.
Unlock: press the safety button 6.
Lock: hold the ceramic plates together and press the
safety button 6.
TECHNICAL DATA
Continuous temperature control (150 °C to 220 °C)
Nominal voltage: 100–240 V~ 50/60 Hz
Nominal input power: 43 W
GB
08/05
17