LOTRONIC Party Manual De Usuario página 2

MULTIFUNCTION BLUETOOTH MICROPHONE SPEAKER
1. Charging the Battery
Insert the USB lead into a PC or standard USB power adaptor. Insert the charger plug into the speaker charge port (4). The indicator
lights up in red during the charge. It turns off when the battery is fully charged.
2. Description of the functions
1. Microphone
2. - /  /+ Voice changer button:
+: Short push downwards to play the next song. Long push downwards to increase the volume.
: Short push upwards to play the previous song. Long plush upwards to lower the volume.
 : Click the button to play or pause the song. Keep the button pressed for 3 seconds to change your
voice. Keep pressed 3 seconds each time to cycle through the various types of voices until you leave the
function.
3. Micro-SD card slot
4. Micro USB charging port
5. Echo control of the microphone: slide upwards to increase the echo effect or downward to reduce the
echo effect
6. Volume : Slide upwards to increase the microphone volume or downwards to reduce the microphone
volume
7. Power on/off and lamp control
8. LED illumination
9. Speaker
3. Power ON/OFF
Press the POWER button (7) for about 3 seconds to power the unit on and off. The speaker will be in Bluetooth mode.
Press the button shortly to switch into light mode.
When a TF card is inserted, the unit switches automatically into TF mode.
4. Bluetooth Pairing Procedure
The speaker supports Bluetooth devices with A2DP function.
Switch the unit on (long press). Press again to enter into Bluetooth pairing mode. The Bluetooth indicator will flicker in blue which
means that the unit is in pairing state. Activate the Bluetooth function on your Bluetooth-enabled device and select KAMIC-BK-VC
or KAMIC-SI-VC (depends on the color of your speaker mic) in the list of found devices.
If the speaker has been connected before to your Bluetooth device, it will connect automatically.
Only one Bluetooth device can be connected at the same time to the unit.
The unit can't connect to another Bluetooth device as long as it is connected to the first one. Disconnect the first device before
you can pair another device.
5. Lamp function
Press the POWER button shortly to turn on the light.
Press again to change the color in following sequence: Red – dark blue – green – pink – sky blue – automatic cycling through the
colors – react to the rhythm of the music - OFF.
IMPORTANT NOTE ON BATTERIES
1. PRIOR to using the unit for the first time, please charge fully the battery without any interruption.
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely, otherwise it will lose 20% of its capacity or even be totally damaged!
If the voltage becomes too low, the internal circuits are not powered anymore and it will become impossible to recharge the
©Copyright LOTRONIC 2019
GB
2 KAMIC-VC