Atlas Copco HBS 65 Instrucciones De Uso página 3

Brief description
Clamping lever
Sanding belt support
Locking button
On-/off switch
Suction connector
Adjusting screw for belt
Integrated dust removal
Changing the
belt
ENGLISH
Dust bag
Prior the changing belt, adjust sanding belt
by turning the belt adjusting screw approx.
2–3 cm in the direction of the open side of
the machine beyond the rollers, whilst the
machine is running, as the new sanding
belt can sometimes brush against the
machine housing.
Always disconnect the plug from the
socket before carrying out any work on the
machine.
1.
Pull the clamping lever forwards
2.
Remove the worn belt and fit the inside of
the belt is pointing in the same direction as
the arrow on the machine.
3.
Push the clamping lever back again
4.
Taking a test run, position the sanding belt
with the aid of the belt adjusting screw so
that it is flush with the outer edge of the
sanding belt support.
2
Modifications: Text, diagrams and data are correct at the time of
printing. In the interest of continuous improvement of our products,
technical specifications are subject to alteration without prior notice.
HBS 65