Button Function; Function Menu - Ibiza Light LED-UV24 Manual De Uso

MASTER/SLAVE FIXTURE LINKING
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the
output as stated above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initial-
ized for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow
may also require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete
instructions for this type of setup and configuration.
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD Display..
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER Used to select and store the current menu or option within a menu
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach function you
wish to change. When you reach the function you wish to change, press the ENTER button. When a function
is selected, use the UP or DOWN buttons to change the function settings. Once your changes are made, press
the ENTER button, and then press and hold the MENU button for at least three seconds to confirm and lock the
change into the system memory. To exit without making any adjustments, press the MENU BUTTON. The display
will lock after 30 secondes. Press the MENU button for 3 seconds to unlock

FUNCTION MENU

d001 d512
Au1
Au2
Au3
Au4
Au5
Au6
Auxx
Au7
Au8
Au9
Au10
So01
So02
St00
St00
St01->St16
SP00 SP16
R01 UV255
G01 UV255
b01 UV255
W01 UV255
4
Manual - LED-UV24
OPERATING INSTRUCTIONS
DMX Address setting
Auto mode 1
Auto mode 2
Auto mode 3
Auto mode 4
Auto mode 5
Auto mode 6
Auto mode 7
Auto mode 8
Auto mode 9
Gradual change
Sound control Jump change
Sound control Strobe
Auto master without strobe
Auto master strobe speed from slow -> fast
Auto master Au08/Au09/Au10 speed from slow -> fast
UV max brightness setting for Row 1
UV max brightness setting for Row 2
UV max brightness setting for Row 3
UV max brightness setting for Row 4
©Copyright LOTRONIC 2020
8.8.8.8.
MENU UP DOWN ENTER