ZKX Audio KW815 Manual Del Usuario página 14

7. LCD DISPLAY SHOWING
1. Turn on the receiver, it will show the name of the factory.
2. After showing the factory`s name, go into the work state.
CH01 803. 90M
00d B AF
CH 01: Show choosing the 10th channel, this machine has 16 different channels fou choosing. Press the up key or down key
choosing the right channel.
803.90 MHz: Show now using the frequency is 803.90 MHz. The frequency of the receiver must same as the transmitter`s
frequency then it can work. Press the up key or down key to change the frequency.
A B : Show the directional of the signal choosing (DIVERSITY). When antenna A signal was weak, the receiver will immediately
change to antenna B to receive the signal, so make the signal no break.
- - D B : Showing signal level.
A F : Showing audio level direction.
3. Pressing "SET" tune selector, come into the manual frequency select mode:.
Pressing UP or DOWN function key to change
the its` frequency, it can step up or
4. Turn off the receiver, show the factorys` name, and then the LCD gone out.
When next time you turn on the machine, it will keep the frequency that last time you used itself.
8. SPECIFICATIONS
1. COMPREHENSIVE
Carrier frequency:
Frequency stabilization:
Dynamic range:
Total harmonic distortion:
Frequency response:
Audio output level:
- Separate type:
- Mix tipe:
step down 0.05 MHz.
UHF 800 Mhz
lees than +/- 30 ppm
more than 90 dB
less than 0.5%
40 Hz—15KHz +/- 3 dB
0-- +/- 400mV
0-- +/- 200mV
- page 13 -
OPERATION MANUAL KW815 OPERATION MANUAL KW815
TUNE 806. 00M
00d B AF
#13