Juguetronica VR Smartview Manual De Instrucciones página 8

PARTS OF THE CONTROL
Absolute
Control
Up / Down
Rotate Right
Rotate Left
Speed Exchange
Unlock
Automatic
landing
BATTERY INSTALLATION IN THE CONTROL
1.5V AA
DEPARTURE
1. Connect the battery to the microdrone Smartview
and turn it on.
ADVICE:
When synchronize your microdrone Smartview VCAM HD, be sure that it is on
a flat, horizontal surface so that the flight is stable.
PRECAUTIONS
1. When the control LED remains lit but the microdrone Smartview LED flashes slowly, it
indicates that synchronization has not been performed correctly. Turn off the control of the
drone and perform again the "departure" from the beginning.
2. If at the start flying the microdrone Smartview does not maintain stably flight, lands it turn
off both control and drone and resynchronizes paying special attention to the microdrone
Smartview be placed on a flat and horizontal surface parallel to the floor.
3. If the microdrone Smartview LED flashes slowly, the battery is running out. Land and
charge the drone of the battery with the USB charger provided.
Return home
automatically
Charge
indicator
Batteries lid
1.5V AA
3. When the LED indicators of microdrone Smartview pass from a
quick flashing to slow, push the power lever (left) to the highest
position and then move it to the lowest position. The control will
emit a beep to confirm that the synchronization was successful. In
the following section, press the Unlock button and the propellers
begin to rotate. You also can do it simultaneously pushing both
levers diagonally outward and downward.
Forward
Backward
trimming
trimming
Displacement right / left
Right displacement
trimming
Left displacement
trimming
Remove the lids of the batteries with a
screwdriver. Put 4 "AA" batteries (not
included), 2 on each side control, and place
again the battery lids screwing it.
1. Place the batteries according to the polarity.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
2. Turn on the control
Forward / Backward
Button stunts