NOTE: If unsuitable cookware or no cookware is present the induction cooker
will display 'E0' for 30 seconds before switching off.
•
To use the timer press the timer button. The LCD display will switch to Timer and the Timer indicator
will illuminate and flash. Press the Increase or Decrease button to change the timer. The Timer
indicator will flash while the timer is in use. When the timer finishes the hob will switch off.
•
To lock the control panel, press the Lock button. To unlock, press and hold the lock button.
•
This appliance has an overheat protection function. If the pan becomes too hot the appliance will
switch off, a buzzer will sound and the display will show "E2". Should this happen, wait for 10 minutes
to allow the appliance to cool before restarting, as above.
•
Fan will continue to run while the glass surface temperature is over 80°C.
Cleaning, Care & Maintenance
Disconnect from the power supply and allow the appliance to cool before
cleaning.
•
Use warm, soapy water and a damp cloth to clean the appliance.
•
DO NOT use abrasive cleaners or pads.
•
Dry thoroughly after cleaning.
•
A CATERLITE dealer or qualified technician should carry out repairs if required.
Troubleshooting
If your Caterlite appliance develops a fault, please check the following table before making a call to the
Helpline
Fault
The unit is not working
"E0" on Display
"E2" on Display
Technical Specifications
Model
Voltage
220-240V
CM352
50/60Hz
CM352_ML_A5_v4_20181224.indb 5
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Unsuitable cookware
Appliance has overheated
Power
Power
Current
(max.)
range
2000W
8A
500-2000W
Solution
Check the unit is plugged in correctly and
switched on
Call Caterlite agent or qualified technician
Replace the plug fuse
Check power supply
Replace with suitable cookware
Allow to cool for 10 minutes before restarting
Temperature
Dimensions
range
h x w x d (mm)
60-240°C
45 x 295 x 370
UK
Weight
2.6kg
5
2018/12/24 15:58