For Your Safety - Wurth Master MSF 30 Instrucciones De Servicio

GB
It is only possible to work
safely with this product if the
user reads these operating
instructions and the safety
instructions in their entirety,
fully
instructions and strictly follows
the information given.
The product must not be damp and
is also not allowed to be operated in
a damp environment.
Check cable and connector each
time prior to using the product. Have
damage repaired by a specialist.
Wear safety glasses.
Wear ear defenders and dust mask.
Wear safety gloves and sturdy
shoes.
Ensure that there are no electricity
cables, water or gas pipes in the
product's cutting area (e.g. check
using a metal detector).
10

For your safety

understands the
Provide adequate ventilation and only work
with an adequately dimensioned extraction unit
suitable for the purpose.
The auxiliary handle 2 must be used during all
work with the product.
Never operate product without guard 9.
Only use diamond cutting discs approved for a
speed that is at least as high as the product's
maximum no-load speed.
Diamond cutting discs must be stored and
handled carefully in accordance with the
manufacturer's instructions.
The diamond cutting discs must fit the collar 15
without play. Do not use adaptors or reducers.
Do not continue to use damaged, untrue or
vibrating diamond cutting discs.
Prior to using the product, ensure the diamond
cutting discs are fitted correctly and in
accordance with the manufacturer's instructions.
Prior to using the product, leave to run at no-
load for at least 30 seconds in a safe position.
If heavy vibration or other defects are detected,
immediately shut down the product and
rectify cause of the fault.
Always ensure you are standing securely when
working.
Feed cable away from product to the rear.
The material to be worked must be securely
fastened.
Keep hands away from rotating diamond cutting
discs.
Do not brake diamond cutting discs that are
running on by applying pressure to the side.
Ensure that sparks produced during the usage of
the product do not cause a hazard (e.g. injuries,
ignition of inflammable substances). Cordon off
hazardous area and have suitable extinguishing
equipment at hand.
Only use original Würth accessories.