Safety And Installation Notes - Wisi VS 50 PRO Instrucciones De Manejo

Convertidor de filtrado programable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

 
Safety and installation notes – please observe
Caution
The mains voltage must match the rated input voltage of the unit .
Connecting cable
Lay the cable so that no one can trip over it.
Lay the cable with a downward loop so that any condensing on it can drip on the floor
instead of running into it.
Selecting the installation location
Excessive temperatures will reduce the operating lifetime of the unit.
Do not install the unit directly above or in the vicinity of radiators
or heating systems where it would be subjected to thermal radiation or oil vapours.
Moisture
Water dripping or splashing onto the unit will damage it. If there is condensation
on the unit, wait until this has evaporated before switching the unit on.
Caution – danger!
In accordance with EN 50 083-1, the antenna system must comply with the safety
requirements with respect to grounding, potential equalisation, etc...
Service work
Service work may be carried out only by qualified personnel.
Always disconnect the supply voltage before starting any such work.
Cleaning
Only use a dry soft cloth to clean the cabinet.
Do not use solvent.
 
‐ 5 ‐ 
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido