Parts Replacement; Electrical Diagram - Koblenz LC-5025 B Manual De Servicio

1.- TO REMOVE THE LID (1)
1.1.- Remove the three screws (5).
1.2.- Lift the lid top cover (3), making sure not to stretch the flexible metal tube (27).
1.3.- Remove the lid (1), bending out the tabs of the cover to disengage the hinge.
1.4.- To reassembly follow the same steps in reverse order.
2.- TO REMOVE THE TIMER (6)
2.1.- Remove the two screws (22) of the rear cover 833) and separate the cover.
2.2.- Remove the four electrical connectors 854) and disconnect the cables from the timer (7), the motor (50) and the line cord (25).
2.3.- Remove the timer knob (4) pulling it out of the timer shaft.
2.4.- Remove the three screws (5) that hold the lid top cover (3), and remove the panel with the timer and the flexible tube.
2.5.- Remove the screw (9) and 11ft the timer cover (10) with the metal tube, taking care to slide the electrical cables out of the metal tube.
2.6.- Remove the two screws (8), lift the timer and replace it.
2.7.- To reassemble follow the same steps in reverse order.
3.- TO REMOVE THE SHAFT ANO BEARING ASSEMBLY (26)
3.1.- Remove the Impeller screw (15) with the conical washer (16), and pull the impeller out of the shaft.
3.2.- Follow the steps of points 2.1 and 2.2.
3.3.- Remove the "V" Belt 838).
3.4.- Remove the six screws (59) that hold the base to the cabinet and separate the base.
3.5.- Place the cabinet horizontally over the bench, extract the pin (29) from the impeller pulley and remove the pulley.
3.6.- Turn loose and remove the nut (36).
3.7.- Remove the complete shaft and bearing assembly pulling out from the interior of the tub and replace.
3.8.- To reassemble follow the same steps in reverse order, make sure the gasket (19) is in position between the shaft assembly (26) and the tub
bottom.
4.- TO REMOVE THE MOTOR (50)
4.1.- Follow the steps 2.1, 2.2, 3.4 and 3.5.
4.2.- Remove the nut (43) and washer (44) that holds the ground terminal of the line cord (25).
4.3.- Disassemble the capacitor (50).
4.4.- Turn loose the set screw (40) on the motor pulley (39) and remove the pulley and fan assembly.
4.5.- Remove from the motor the three screws (51-49) and washer (52), with a screwdriver.
4.6.- Remove the motor (50) and disassemble the three motor supports (57).
4.7.- To reassemble follow the same steps in reverse order.
II. PARTS REPLACEMENT
III. ELECTRICAL DIAGRAM / DIAGRAMA ELECTRICO
4/10
Elaborado: Mayo / 2005